LitaElek 10pcs RGB 5050 LED Strip Corner Connector 10mm 4 pin RGB LED Tape L-Shape Connector Splitter LED Ribbon Right…

Installation instructions:
Make sure your LED strip is a 10 mm wide 4-pin RGB LED strip with four contacts (+, B, R and G).
– Open the caps of the connector.
When you use a non-waterproof LED strip, insert the LED strip light directly into the clip, ensure that the 4 contacts of the LED strip fit under the 4 prongs of the connector, make sure the ” +” side of the strip fits onto the ” +” side of the connector;
If you use a waterproof LED strip, you should detach silicone from the surface, install the LED lighting strip directly into the clip, ensuring that the 4 contacts of the LED strip locate under the 4 prongs of the connector, make sure to fit the ” +” side of the strip to the “+” side of the connector.
– Close the cap of the connector.

Important note:
If the LEDs flicker or fail to light up, this indicates that there is a poor contact between the L-shaped connector and the LED strip. To solve the problem, please follow these steps:
Turn on the LED strip.
– Open all caps of the corner connector.
– Place the LED strip in the corner connector, pull it gently and slide the LED strip to adjust the point of contact between the 4 copper contacts on your LED strip and to adjust the 4 prongs in the connector. If the LEDs still fail to light, please use your finger to press down a little harder on the 4 prongs in the connector.
– If the LEDs still fail to light, please place the contact point between the 4 copper contracts on the L-shaped PCB and insert the 4 prongs in the connector until the LEDs light up.

Contents:
10 x LitaElek corner connector for 10 mm RGB LED strip with 4 copper contacts on the intersection line (white).

Thanks to the L-Form cleanly laid, no twisting or damage to your LED lighting strip, particularly when installing over an edge.
Easy to install, no tools, easy to assemble and ready.
The installation of LED strips over corner has never been so easy and never so good.
Simple and cost effective plug-in connector for mounting lights around any corner.
Suitable for 10 mm wide 4-pin RGB LED strip with 4 copper contacts on the intersection line, set of 10 L-shaped and 20 quick connectors.